User manual

11
Figure-13 Using masking tape to shim the
extension wing up
If the mating surface of the extension wing
tilts up, use a masking tape along the top
edge if the main table to shim the extension
wing down.
Figure-14 Using masking tape to shim the
extension wing down
When the table is reinstalled, remove the
excessive masking tape using a blade.
Once the extension wings are properly
installed to the main table, attach the front
fence rail to the main table and extension
wings. Insert four bolts into the four larger
holes on the main table and extension
wings. Place a lock washer and a nut onto
each bolt from the inner side of the table.
Thread the nut a few turn onto the bolt and
do not tighten as shown in figure-15.
Figure-15 Nut and bolt to secure the front
fence rail to the table and wings
Slide the smaller front fence rail piece on to
the bolt through the slot on the rail and then
slide the larger piece as shown in figure-16
and tighten the nuts.
Figure-16 Installing the front fence rail
Install the rear fence rail in the same
manner.
To install the fence, place it on the rails, on
the right hand side of the blade and push
the fence handle down to lock the fence on
the rails.