User manual

12
Attach the switch to the front fence rail as
shown in figure-17, using screws and
washers provided.
Figure-17 Installing the switch
Install the motor cover by sliding the hinge
posts in the hinges and locking the motor
cover using the lock knob. See figure-18.
Figure-18 Installing the motor cover
INSTALLING THE SAW
BLADE
Remove the table insert. Raise the arbor all
the way up using the blade height hand
wheel located on the front of the saw and
set the blade to 0-degree.
Remove the arbor nut and the arbor flange
and install the 10” blade provided. Make
sure the teeth of the blade are facing the
front of the saw. Install the arbor flange
and the arbor nut and tighten using arbor
wrench and locking pin provided.
Figure-19 Installing the blade