User manual

13
BLADE GUARD
SPREADER
Make sure the switch is in the OFF position
and the cord is disconnected from the
power source.
Remove the table insert (if already
installed) and loosen the lock handle to
open the bracket.
Now, slide the blade guard spreader, down
into the bracket and tighten the lock handle
to engage the bracket. Make sure the
spreader is locked properly. See figure-20.
Figure-20 Installing the spreader
TABLE INSERT
Make sure to clean the dust or the dirt on
the table throat before installing the insert.
The dust or dirt can cause the insert to be
out of height alignment.
Place the table insert in the table throat and
make sure it is level with the table surface.
INSTALLING THE BLADE
GUARD
Attach the blade guard to the spreader as
shown in figure-21.
Figure-21 Installing the blade guard
Once the blade guard is attached to the
spreader, turn the lock handle down to lock
the blade guard on the spreader as shown
in figure-22.
Figure-22 Securing the blade guard to the
spreader