User manual

14
BASIC CONTROLS
The basic controls of this machine are
shown in the figure-23. Use the figure and
read the text to understand what the basic
controls of your CX202 are.
Figure-23 Basic controls on CX202
A. ON / OFF Switch
The ON / OFF switch on your CX202 has a
green button to turn the machine “ON” and
a red button to turn the machine “OFF”,
when pressed. It also features a locking pin
which prevents from accidental or un-
authorized start ups.
B. Blade Height Hand Wheel
It is used to raise and lower the blade. If
you want to adjust the blade height, turn the
hand wheel to raise or lower the blade.
C. Blade Tilt Hand Wheel
It is used to adjust the angle of the blade. If
you want to adjust the blade angle, loosen
the lock handle (in front of the saw, under
the table) and turn the hand wheel. When
the blade is at the desired angle, retighten
the lock handle.
TEST RUN
Once you have assembled your machine
completely, it is then time for a test run to
make sure that the machine works properly
and is ready for operation.
During the test run if there is any unusual
noise coming from the machine or the
machine vibrates excessively, stop the
machine immediately and disconnect from
the power source and investigate to find out
the problem with your machine.
Check all the safety features on the
machine and make sure all the safety
features work properly.
WARNING
For the protection of your eyes, make
sure you are wearing safety glasses or
safety goggles while doing the test run.
Before starting the table saw, make sure
that you have read and understood the
manual and you are familiar with the
functions and safety features on this
machine
READ THE
MANUAL
WARNING
The safety instructions given in this
manual can not be complete because the
environment in eve
ry shop is different.
Always consider safety first as it applies
to your individual working conditions.