User manual

19
Figure-30 Marking the angle of cut
BEVEL CUTS
The CX202 blade can be tilted to the left
between 0° and 45° by rotating the blade tilt
hand wheel. This feature of the saw allows
making bevel cuts.
To make bevel cuts, loosen the blade tilt
lock handle. Rotate the blade tilt hand
wheel to the desired angle, looking at the tilt
scale and lock the hand wheel by
retightening the lock handle.
After that, proceed to make the cut in the
same manner as in “Cross Cutting”.
FENCE SCALE
ADJUSTMENT
To adjust the fence and the rails, make sure
the switch is in the OFF position and the
cord is disconnected from the power
source.
Remove the blade guard and Slide the
fence against the saw blade and push the
fence handle down to lock it on the rails.
The “0” on the scale tape (to the right side
of the blade) is aligned with the red line on
the optical cursor attached to the right side
of the fence.
Now remove the fence and place it on the
rails to the left side of the blade. Check if
the “0” on the tape scale it aligned with the
red line on the optical cursor. If not then the
fence rails needs to be adjusted.
To adjust the fence rails, loosen the nuts
and bolts securing the fence rails to the
table and extension wings. Slide the fence
rails so that the “0” on the scale tapes, on
both sides of the fence are aligned with the
red lines on both optical cursors on the left
and right sides of the fence.
Re-tighten the nuts and secure the fence
rails to the main table and extension wings.
Figure-31 Aligning the red line with the “0”
For more accurate angles, and to check
that your saw blade is at the exact angle
you need, use
a digital angle finder.
Model# B2646
or
Model# WR300