User manual

21
hand-wheel. Place the straight edge against
the top and bottom part of the spreader or
riving knife as shown in figure-34.
Figure-34 Using a straight-edge to check
the top and bottom alignment
If the spreader or riving knife is not parallel
with the blade, remove it and place it on a
flat surface. Check if it lays evenly on the
flat surface along its length.
If the spreader or riving knife does not lie
evenly, bend it with your hands until it is
straight.
REPLACING THE V-BELT
Make sure the switch is in the “OFF”
position and remove the cord from the
power source.
Loosen the screws holding the plastic plate
cover beside the blade and remove the
plastic plate. See figure-35.
Figure-35 Removing the plastic plate
Raise the blade to the maximum and
remove the blade guard, the table insert
and the spreader.
Open the motor cover and loosen the bolt
securing the motor as shown in figure-36.
Move the motor up and remove the V-belt
from the pulleys.
Figure-36 Loosening the motor mounting
bolt
Install the new V-belts onto the pulleys and
lower the motor to tension the belt. When
the belt is correctly tensioned, retighten the
bolt and close the plastic motor cover.