User manual

22
ON / OFF SWITCH
The CX202 is equipped with a push button
switch that will accept a padlock (not
included) for locking the switch in the OFF
position. See figure-37.
Figure-37 Locking the switch in the OFF
position
To safeguard your machine from un-
authorized operation and accidental starting
by young children, the use of padlock is
necessary.
MITER GAUGE
ADJUSTMENT
The miter gauge provided with CX202 can
be set at 0° and plus or minus 45° with the
gauge stop pin and adjustable stop screws.
To adjust the miter gauge:
Loosen the knob and pull out the stop pin.
Loosen the lock nut of the 0° stop screw at
the stop pin with an 8mm wrench.
Place a 90° square against the miter gauge
rod and the miter gauge base. If the rod is
not square, loosen the knob, adjust the rod,
and tighten the knob.
Adjust the 0° stop screw until it rests
against the stop pin. Adjust the plus and
minus 45° stop screws using a 45° triangle
and the steps above.
Figure-38 Adjusting the miter gauge
MAINTENANCE
1. The unpainted components such as the
precision-ground cast-iron table top
should be protected with a coat of paste
wax and then buffed dry.
2. Regularly vacuum all sawdust from the
saw’s interior and vacuum the motor
openings as well.
3. Check drive belts for wear and correct
tension on a regular basis.
4. Check that the blade guard and anti
kickback pawls operate properly.
IMPORTANT
Miter gauge provides close accuracy in
angled cuts. For very close tolerance,
test cuts are recommended.