User manual

10
Insert the rod into the hole as shown in
figure-9 making sure that the flat surface of
the rod is facing the hole on the bracket.
Use the knob provided, and secure the rod
in position.
Figure-9 Securing the table rod into the
hole
Position the table with the hole at the back
of the table onto the rod and secure it by
tightening the screw and then the nut
shown in figure-10.
Figure-10 Installing the table onto the rod
The table is used with CX505 only when the
table is in vertical position.
WORKPIECE STOP
Loosen the knob securing the dust hood in
position and move the dust hood out of the
way. Re-tighten the knob to hold the dust
hood in position.
Take the work-piece stop and install it by
inserting the shaft on the work-piece stop
into the hole. Use a flat washer and a long
knob securing the work-piece stop onto the
sander. See figure-11.
Figure-11 Installing the work-piece stop
BELT TRACKING
Belt tracking means where the belt rides on
the drums. The belt should always be
centered on both drums.
IMPORTANT
The dust hood can not be properly
closed when the table is installed on the
sander. In order to use dust hood with
your sander, uninstall the table
whenever the table is not being used.