User manual

12
TEST RUN
Once you have assembled your machine
completely, it is then time for a test run to
make sure that the machine works properly
and is ready for operation.
Before starting the sander for a test run
make sure you have performed the belt
tracking adjustment (see page-10) so that
the belt does not come off the drums or jam
against the sander during startup.
To test run the sander:
Make sure you have read and understood
all the instructions given in the manual,
safety features on your CX505 sander and
the machine is assembled properly.
Remove all the tools and objects used
during assembly from the machine. Ensure
the belt tracks properly on the drums.
Connect the machine to the power source
and turn it ON and be ready to turn it OFF
quickly if there is any problem during
startup.
During the test run if there is any unusual
noise coming from the machine or the
machine vibrates excessively, stop the
machine immediately and disconnect from
the power source and investigate to
determine the problem with your machine.
Make sure all the nuts and bolts are
tightened and all the parts are installed
properly during assembly.
WORKPIECE INSPECTION
CX505 is designed to sand wood only. Do
not use this machine to sand metals, glass
or stone etc.
Before sanding, make sure to inspect the
work-piece for nails, staples, small pieces
of stone or metal, and any other foreign
objects that can damage the sanding belt if
come in contact
Sanding the work-piece with this kind of
objects can tear the sanding paper. For a
safe cutting method always inspect your
work-piece carefully before cut and wear
eye protection.
Some woods with excessive finish or glue
load up the sand paper and reduce its
usefulness. Use an abrasive cleaner to
clean the sanding paper.
CONNECTING TO A DUST
COLLECTOR
The CX505 is equipped with a 4” diameter
dust hood to connect to a dust collector.
When connecting to a dust collector, use a
proper sized hose and make sure all the
connections are sealed tightly. It is
recommended to use a proper sized dust
collector with the CX505 to ensure
adequate dust collection.
WARNING!
Before starting the sander, make sure
that you have read and understood the
manual and you are familiar with the
functions and safety features on this
machine. Failure to do so may cause
serious personal injury.
WARNING!
The saw dust produced by the band saw
can go into your lungs and cause serious
health problems. Make sure the band
saw is connected to a dust collection
system while operating it.