User manual

TROUBLESHOOTING

TROUBLE CAUSES CORRECTION

Motor doesn’t start. 1. No electricity.

2. Defective switch, motor or

cord.

3. Overload has reacted.

1. Check mains and fuse.

2. Consult an electrician.

3. Wait and reset overload

cut-off.

Sanding belt slips. 1. Sanding belt is stretched.

2. Too much applied pressure.

1. Install new sanding

belt.

2. Move work piece while

sanding.

Machine vibrates

excessively.

1. Stand on uneven floor.

2. Motor mounts are loose.

1. Adjust stand for even

support.

2. Tighten motor mount

belts.

Abrasive belt keeps tearing. 1. Belt is running the wrong

direction.

1. Observe arrow on the

sanding belt.

Sanded edge not square. 1. Table not square to sanding

platen.

1. Adjust positive stop for

90°.

Sanding marks on the wood. 1. Work piece was held still.

2. Wrong grit sanding belt.

3. Feed pressure too high.

1. Keep work piece

moving.

2. Use coarser grit for

stock removal and fine

grit for finish sanding.

3. Never force the wood.