Installation Guide

ASSEMBLY & INSTALLATION
IN STRUCTION FOR #26122
Please read carefully and save these instructions, as you may need them at a later date.
GENERAL
All electrical connections must be in accordance with local and National Electrical Code (N.E.C.) standards. If
you are unfamiliar with proper electrical wiring connections obtain the services of a qualified electrician.
Remove the fixture and the mounting package from the box and make sure that no parts are missing by
referencing the illustrations on the installation instructions.
CAUTION
Turn off the main power at the circuit breaker before installing the fixture, in order to prevent possible shock.
17. DECO. NIPPLE
18. GLASS SHADE
19. PLATE COVER
20. HEX NUT
21. BOTTOM COVER
22. FINIAL
FIG
ASSEMBLY AND INSTALLATION
1. At the center of the BACK PLATE(2) there are eight perforated slots. Knock out the set matches your
OUTLET BOX (1).
2. Screw the FIXTURE MOUNTING SCREWS (13) into the BACK PLATE (2) and thread the HEX
NUTS (14) onto the FIXTURE MOUNTING SCREWS (13), as shown. Secure the position of the
FIXTURE MOUNTING SCREWS (13) by tightening the HEX NUTS (14) against the BACK PLATE
(2).
3. Carefully pass the power supply (6&8) wires and the SUPPLY GROUND WIRE (5) through the center
hole of the BACK PLATE (2). Secure the BACK PLATE (2) to the OUTLET BOX (1) with
MOUNTING SCREWS (3).
4. Attach the BLACK SUPPLY WIRE (8) to the SMOOTH (or BLACK) FIXTURE LEAD WIRE (9) by
using the WIRE CONNECTOR (10). At the same manner, attach the WHITE SUPPLY WIRE (6) to
the RIBBED (or WHITE) FIXTURE LEAD WIRE (7). Loop the FIXTURE GROUND WIRE (4)
around the GROUND SCREW (11) of the BACK PLATE (2). (Note: Be sure to provide an extra 3”
length of the FIXTURE GROUND WIRE (4) for connection to the SUPPLY GROUND WIRE (5).)
Tighten the GROUND SCREW (11). Connect the remaining FIXTURE GROUND WIRE (4) to the
SUPPLY GROUND WIRE (5) using a WIRE CONNECTOR (10). Place wiring and connections
inside the OUTLET BOX (1).
5. Place the COVER PLATE (12) onto the FIXTURE MOUNTING SCREWS (13), and secure it into
place using the DECORATIVE NUTS(15) provided.
6. Screw light bulbs into the sockets and make sure they do not exceed the maximum wattage
specified on the fixture’s wattage rating label,
MAXIMUM 60W.
7. Thread the DECO.NIPPLE(17) onto the COUGPLING(16), secure in position with the hex nut. Slide
the GLASS SHADE(18) and the PLATE COVER(19) over the DECO. NIPPLE(17), secure with the
HEX NUT(20). Slide the BOTTOM COVER(21) over the DECO. NIPPLE(17), secure with the
FINIAL(22).
1. OUTLET BOX
2. BACK PLATE
3. MOUNTING SCREW
4. FIXTURE GROUND WIRE
5. SUPPLY GROUND WIRE
6. WHITE SUPPLY WIRE
7. RIBBED (OR WHITE) FIXTURE
LEAD WIRE
8. BLACK SUPPLY WIRE
9. SMOOTH (OR BLACK)
FIXTURE LEAD WIRE
10. WIRE CONNECTOR
11. GROUND SCREW
12. COVER PLATE
13. FIXTURE MOUNTING
SCREW
14. HEX NUT
15. DECORATIVE NUT
16. COUPLING