Installation Guide

Please read carefully and save these instructions, as you may need them at a later date.
Turn off the main power at the circuit breaker before installing the fixture in order to prevent
possible shock.
All electrical connections must be in accordance with local and National Electrical Code (N.E.C.)
standards. If you are unfamiliar with proper electrical wiring connections, obtain the services of a
qualified electrician.
Remove all parts and hardware from the box and make sure that none are missing by referencing
the illustrations provided.
1. Remove the DECORATIVE NUTS (14) from the FIXTURE SCREWS (12) and remove the
MOUNTING STRAP (2) from the CANOPY (11). Secure the position of the FIXTURE
SCREWS (12) by tightening the HEX NUTS (12) against the MOUNTING STRAP (2).
2. Carefully pass the SUPPLY WIRES (4 & 6) and the SUPPLY GROUND WIRE (9) through the
center hole of the MOUNTING STRAP (2). Secure the MOUNTING STRAP (2) to the OUTLET
BOX (1) (not included) with OUTLET BOX SCREWS and WASHERS (3).
3. Thread TUBE-C (18) onto the SOCKET ASSEMBLY (19), TUBE-B (17) onto TUBE-C (18),
and TUBE-A (16) onto TUBE-B (17). Thread the SWIVEL ASSEMBLY (15) onto TUBE-A (16).
4. Attach the BLACK SUPPLY WIRE (4) to the SMOOTH (or BLACK) FIXTURE LEAD WIRE (5)
by using the WIRE CONNECTOR (10). In the same manner, attach the WHITE SUPPLY WIRE (6)
to the RIBBED (or WHITE) FIXTURE LEAD WIRE (7). Loop the SUPPLY GROUND WIRE (9)
around the GROUND SCREW (13) on the MOUNTING PLATE (2). [Note: Be sure to provide an
extra 3in. length of the SUPPLY GROUND WIRE (9) for connection to the FIXTURE GROUND
WIRE (8).] Tighten the GROUND SCREW (13). Connect the remaining SUPPLY GROUND
WIRE (9) to the FIXTURE GROUND WIRE (8) using a WIRE CONNECTOR (10). Push wiring
and connections inside the OUTLET BOX (1).
5. Place the CANOPY (11) over the FIXTURE SCREWS (12) and secure CANOPY (11) with the
DECORATIVE NUTS (14) provided.
6. Remove the SOCKET RING (21). Secure the GLASS SHADE (20) with the SOCKET RING (21).
7. Install bulb, MAXIMUM 60W.
INSTALLATION IS NOW COMPLETE
# 28521-AN
GENERAL
ASSEMBLY AND INSTALLATION
CAUTION
1-LIGHT MINIPENDANT
12. FIXTURE SCREW and HEX NUT
(pre-attached)
13. GROUND SCREW (pre-attached)
14. DECORATIVE NUT
15. SWIVEL ASSEMBLY (pre-attached)
16. TUBE-A
17. TUBE-B
18. TUBE-C
19. SOCKET ASSEMBLY
20. GLASS SHADE
21. SOCKET RING
WILLOW PARK
Customer Service: 1 [phone]
1. OUTLET BOX (NOT INCLUDED)
2. MOUNTING STRAP
3. OUTLET BOX SCREW and WASHER
(pre-attached to outlet box)
4. BLACK SUPPLY WIRE (not included)
5. SMOOTH (or BLACK) FIXTURE LEAD WIRE
6. WHITE SUPPLY WIRE (not included)
7. RIBBED (or WHITE) FIXTURE LEAD WIRE
8. FIXTURE GROUND WIRE
9. SUPPLY GROUND WIRE (not included)
10. WIRE CONNECTORS
11. CANOPY
16
1
14
9
6
4
2
8
10
7
5
11
19
20
21
18
17
15
13
3
12