Installation Guide

# 28561-GB
1. OUTLET BOX (NOT INCLUDED)
2. MOUNTING PLATE
3. OUTLET BOX SCREW and WASHER
(pre-attached to outlet box)
4. BLACK SUPPLY WIRE (not included)
5. SMOOTH (OR BLACK) FIXTURE LEAD WIRE
6. WHITE SUPPLY WIRE (not included)
7. RIBBED (OR WHITE) FIXTURE LEAD WIRE
8. FIXTURE GROUND WIRE
9. SUPPLY GROUND WIRE (not included)
10. WIRE CONNECTOR
11. DECORATIVE NUT
12. SHADE
13. FIXTURE
14. GROUND SCREW (pre-attached)
15. FIXTURE SCREW and HEX NUT
(pre-attached)
16. CANDLE COVER (pre-attached)
Please read carefully and save these instructions, as you may need them at a later
date.
Turn off the main power at the circuit breaker before installing the fixture in order to
prevent possible shock.
All electrical connections must be in accordance with local and National Electrical
Code (N.E.C.) standards. If you are unfamiliar with proper electrical wiring
connections obtain the services of a qualified electrician.
Remove all parts and hardware from the box and make sure that none are missing by
referencing the illustrations provided.
1. Remove DECORATIVE NUTS (11) from FIXTURE SCREWS (15) on MOUNTING
PLATE (2).
2. Carefully pass the power SUPPLY WIRES (4 & 6) and the SUPPLY GROUND WIRE (9)
through the center hole of the MOUNTING PLATE (2). Secure the MOUNTING PLATE
(2) to the OUTLET BOX (1) (not included) with existing OUTLET BOX SCREWS and
WASHERS (3).
3. Attach the BLACK SUPPLY WIRE (4) to the SMOOTH (or BLACK) FIXTURE
LEAD WIRE (5) with WIRE CONNECTOR (10). In the same manner, attach the
WHITE SUPPLY WIRE (6) to the RIBBED (or WHITE) FIXTURE LEAD
WIRE (7). Loop the SUPPLY GROUND WIRE (9) around the GROUND SCREW
(14) on the MOUNTING PLATE (2). [Note: Be sure to provide an extra 3in. length of
the SUPPLY GROUND WIRE (9) for connection to the FIXTURE GROUND WIRE
(8).] Tighten the GROUND SCREW (14). Connect the remaining SUPPLY GROUND
WIRE (9) to the FIXTURE GROUND WIRE (8) using a WIRE CONNECTOR (10).
Push wiring and connections inside the OUTLET BOX (1).
4. Place the FIXTURE (13) over the FIXTURE SCREWS (15) and secure FIXTURE (13)
with the DECORATIVE NUTS (11) provided.
5. Slide the SHADE (12) over the CANDLE COVER (16).
6. Install bulb, MAXIMUM 60W.
GENERAL
ASSEMBLY AND INSTALLATION
CAUTION
INSTALLATION IS NOW COMPLETE
WILLOW PARK
1-LIGHT WALL SCONCE
Customer Service: 1 [phone]
8
6
9
10
5
7
4
3
11
1
12
13
15
16
14
2