Installation Guide

1. OUTLET BOX (NOT INCLUDED)
2. MOUNTING PLATE
3. OUTLET BOX SCREWS and WASHERS
(pre-attached to outlet box)
4. BLACK SUPPLY WIRE (not included)
5. SMOOTH (or BLACK) FIXTURE LEAD WIRE
6. WHITE SUPPLY WIRE (not included)
7. RIBBED (or WHITE) FIXTURE LEAD WIRE
8. FIXTURE GROUND WIRE
9. SUPPLY GROUND WIRE (not included)
10. WIRE CONNECTORS
11. DECORATIVE NUTS
12. GLASS SHADE
13. THUMBSCREWS
14. CANOPY
15. GROUND SCREW (pre-attached)
16. FIXTURE SCREWS and HEX
NUTS (pre-attached)
17. FIXTURE
1-LIGHT SEMI-FLUSH
Customer Service: 1 [phone]
YORKTOWN #35051-OBG / #35051-PLN
Please read carefully and save these instructions, as you may need them at a later date.
Turn off the main power at the circuit breaker before installing the fixture in order to
prevent possible shock.
All electrical connections must be in accordance with local and National Electrical Code
(N.E.C.) standards. If you are unfamiliar with proper electrical wiring connections obtain the
services of a qualified electrician.
Remove all parts and hardware from the box and make sure that none are missing by
referencing the illustrations provided.
1. Remove DECORATIVE NUTS (11) from the FIXTURE SCREWS (16) and remove the MOUNTING
PLATE (2) from the CANOPY (14). Pull the power SUPPLY WIRES (4 & 6) an
d the SUPPLY GROUND
WIRE (9) out from the OUTLET BOX (1) (not included) and then through the center hole of the
MOUNTING PLATE (2). Secure th
e MOUNTING PLATE (2) to the OUTLET BOX (1) (not included)
with the OUTLET BOX SCREWS and WASHERS (3).
2. Unravel the FIXTURE LEAD WIRES (5 & 7) and FIXTURE GROUND WIRE (8). Attach the power
supply wires to the fixture lead wires by connecting the BLACK SUPPLY WIRE (4) to
the SMOOTH (or BLACK) FIXTURE LEAD WIRE (5) and the WHITE SUPPLY WIRE (6) to the
RIBBED (or WHITE) FIXTURE LEAD WIRE (7). Loop the SUPPLY GROUND WIRE (9) around the
GROUND SCREW (15) on the MOUNTING PLATE (2). [Note: Be sure to provide an extra 3in. length
of the SUPPLY GROUND WIRE (9) for connection to the FIXTURE GROUND WIRE (8).] Connect
the remaining SUPPLY GROUND WIRE (9) to the FIXTURE GROUND WIRE (8). Use a WIRE
CONNECTOR (10) for all wire connections. Push wiring and connections inside the OUTLET BOX (1).
3. Place the CANOPY (14) over the FIXTURE SCREWS (16) and secure with the DECORATIVE
NUTS (11) provided.
4. Install bulb (not included), MAXIMUM 60W.
5. Partially loosen THUMBSCREWS (13) at bottom of FIXTURE (17). Attach GLASS SHADE (12) to
FIXTURE (17) with THUMBSCREWS (13). Do NOT overtighten THUMBSCREWS (13).
INSTALLATION IS NOW COMPLETE.
GENERAL
ASSEMBLY AND INSTALLATION
CAUTION
12
13
17
11
14
1
2
3
16
4
5
6
7
8
9
10
15
16