Installation Guide

ASSEMBLY & INSTALLATION
INSTRUCTION FOR #45091-ESP
Please read carefully and save these instructions, as you may need them at a later date.
GENERAL
All electrical connections must be in accordance with local and National Electrical Code (N.E.C.) standards. If
you are unfamiliar with proper electrical wiring connections obtain the services of a qualified electrician.
Remove the fixture and the mounting package from the box and make sure that no parts are missing by
referencing the illustrations on the installation instructions.
CAUTION
Turn off the main power at the circuit breaker before installing the fixture, in order to prevent possible shock.
FIG.
ASSEMBLY AND INSTALLATION
1. At the center of the BACK PLATE (2) there are eight perforated slots. Knock out the set matches your
OUTLET BOX (1).
2. Screw the FIXTURE MOUNTING SCREWS (13) into the BACK PLATE (2) and thread the HEX NUTS
(14) onto the FIXTURE MOUNTING SCREWS (13) as shown. Secure the position of the FIXTURE
MOUNTING SCREWS (13) by tightening the HEX NUTS (14) against the BACK PLATE (2).
3. Carefully pass the power supply (6&8) wires and the SUPPLY GROUND WIRE (5) through the center
hole of the BACK PLATE (2). Secure the BACK PLATE (2) to the OUTLET BOX (1) with
MOUNTING SCREWS (3).
4. Attach the BLACK SUPPLY WIRE (8) to the SMOOTH (or BLACK) FIXTURE LEAD WIRE (9) by
using the WIRE CONNECTOR (10). At the same manner, attach the WHITE SUPPLY WIRE (6) to
the RIBBED (or WHITE) FIXTURE LEAD WIRE (7). Loop the FIXTURE GROUND WIRE (4)
around the GROUND SCREW (11) of the BACK PLATE (2). (Note: Be sure to provide an extra 3”
length of the FIXTURE GROUND WIRE (4) for connection to the SUPPLY GROUND WIRE (5).)
Tighten the GROUND SCREW (11). Connect the remaining FIXTURE GROUND WIRE (4) to the
SUPPLY GROUND WIRE (5) using a WIRE CONNECTOR (10). Place wiring and connections inside
the OUTLET BOX (1).
5. Adjust the length of CORD (17) by loosening the SET SCREW (16) to get proper height, and then
tighten the SET SCREW (16).
6. Place the CANOPY (12) onto the FIXTURE MOUNTING SCREWS (13), and secure it into place using
the BALL FINIALS (15) provided.
7. Screw light bulb into the socket and make sure it does not exceed the maximum wattage specified on the
fixture’s wattage rating label, MAXIMUM 60W.
INSTALLATION IS NOW COMPLETED
14. HEX NUT
15. BALL FINIAL
16. SET SCREW
17. CORD
18. FIXTURE BODY
19. SOCKET
1. OUTLET BOX
2. BACK PLATE
3. MOUNTING SCREW
4. FIXTURE GROUND WIRE
5. SUPPLY GROUND WIRE
6. WHITE SUPPLY WIRE
7. RIBBED (OR WHITE) FIXTURE LEAD WIRE
8. BLACK SUPPLY WIRE
9. SMOOTH (OR BLACK)
FIXTURE LEAD WIRE
10. WIRE CONNECTOR
11. GROUND SCREW
12. CANOPY
13. FIXTURE MOUNTING SCREW