Installation Guide

Bulb
Roof Assembly
Screws
Roof
Crossbar
Center Screw
Screw Cap
a. Tuck wires back into the electrical outlet box.
b. Attach fixture to crossbar. Tighten cap nuts to hold fixture
to the wall.
c. Remove roof assembly screws. Remove roof and insert bulb. Reattach
roof (see Bulb Installation & Roof Assembly section).
d. To prevent moisture from entering the outlet box and causing a short,
use clear caulking to outline the outside of the fixture's backplate where
it meets the wall, leaving a space at the bottom to allow moisture a
means of escape.
Mount Outdoor Fixture to Wall
Weep Hole
Bottom Finial
Weep Hole
Hex Nut
Short
Threaded
Nipple
Discard
Hex Nut
Remove
Attach
Long
Threaded
Nipple
Tail
Font Assembly
Bottom Finial
Remove bottom finial, font
assembly, short threaded nipple
(discard), and hex nut. Reattach
hex nut, then long threaded
nipple, tail, font assembly with
"weep hole" on bottom. Secure
with bottom finial as shown.
Adding Optional Tail Assembly
Wall Mount
Caulking
Caulk
Backplate
f. Para las unidades con vidrio y tornillo de ajuste delantero, afloje
cuidadosamente el tornillo, quite el vidrio y coloque la bombilla. Vuelva a
unir el vidrio cuidadosamente, ajustando la parte trasera de éste en los
soportes de las repisas. Fije el vidrio con los tornillos de ajuste. Fíjese que
el tornillo de ajuste y el soporte de la repisa estén a distintos niveles en el
vidrio cóncavo (ver la figura 7).
g. Para evitar que entre agua a la unidad de reflector individual, no sitúe la
luz en un ángulo de más de 65 grados en ninguna dirección
(ver la figura 8).
h. Encienda el suministro eléctrico.
Figura 8
Reflectores direccionales
Soporte de
la repisa
Figura 7
Tornillo de ajuste delantero
Tornillo de ajuste
S6
E3
Nota: Los accesorios Z404 se deben montar por lo menos el 18" lejos
de cualquier superficie circundante (ejemplo: paredes adyacentes, proyecciones).