Installation guide

page 9
11. Wall Control Operation.
ON/OFF slider switch - turns wall control ON or OFF
HI button - turns the 2 smaller fans to HIGH speed
MED button - turns the 2 smaller fans to MEDIUM speed
LOW button - turns the 2 smaller fans to LOW speed
FAN OFF button - turns the 2 smaller fans OFF
button - turns main fan ON/OFF when pressed once
(i.e., controls ROTATION of the ENTIRE fan)
10. Automated Learning Process./
Activating Code.
CAUTION: The remote control transmitter can be
programmed to multiple receivers or fans. If this is
not desired, turn wall switch off to any other
programmable receiver or fan.
Remove battery cover on back side of remote
control transmitter.
Use a ballpoint pen or a small screwdriver to set
the code switches 1 through 4 for the transmitter.
Use the same number sequence used when
wiring the wall control in Section 6 (page 6).
Note: Because this fan requires compact
fluorescent bulbs, the dimmer switch (labeled D
and X) has been pre-set to the "OFF" position (X).
[Most compact fluorescent bulbs, including the
ones provided with this fan, are not compatible for
use with dimmer controls.]
Install one 12-volt battery (included) in
transmitter. Re-attach battery cover on transmitter.
IMPORTANT: Store the transmitter away from
excess heat or humidity. To prevent damage to
transmitter, remove the battery if not used for
long periods.
Restore electrical power and then set slider switch
on wall control to the ON position. Within 30
seconds of turning on the wall control, press the
fan "OFF" button ( ), located on the front of the
transmitter, for 5 seconds or until light blinks
twice. Test the light and fan functions to confirm
the learning process is complete--see Section 13.
battery
cover
12V battery
dimmer
switch
code
switches
transmitter
(back)
transmitter
(front)