Installation Guide

page 10
HI button - turns the 2 smaller fans to HIGH speed
MED button - turns the 2 smaller fansto MEDIUM speed
LOW button - turns the 2 smaller fans to LOW speed
button - turns the 2 smaller fans OFF
button - turns light ON/OFF when tapped quickly.
Pressing and holding button down for more
than 0.7 seconds converts it into a dimmer.
button - turns main fan ON/OFF when pressed once
(i.e., controls ROTATION of the ENTIRE fan)
13. Testing Your Fan.
It is recommended that you test fan before
finalizing installation. Locate ON/OFF slider switch
on wall control and set to the ON position. Test
ROTATION/OFF function of main fan with button
used to control rotation of fan; test fan speeds of
smaller fans with different fan speed buttons and
OFF button. Test light with light button. Next,
locate remote control. Test fan speeds (and OFF)
with the different fan speed buttons and then test
rotation of fan (and OFF) as was done with wall
control. Test light with button. If the remote
control operates all of the functions of the fan,
battery has been installed correctly. If the wall
and/or remote controls do (does) not operate all of
the fan/light functions, refer to "Troubleshooting"
section to solve any issues before contacting
Customer Service.
The tilt angle of the smaller fans may be adjusted
up or down by simply moving them gently up or
down.
WARNING: To avoid personal injury or damage to
the fan, both the main fan and the smaller fans
MUST BE TURNED OFF before adjusting the tilt
angle of the smaller fans up or down.
NOTE: If remote control interferes with other
appliances, change code switches on remote
control transmitter and wall control to another
code. If you do change the code, turn power off first
and then remove battery cover. After setting new
code on transmitter (AND wall control), go back to
instructions in last paragraph of Section 10 (page 9).
smaller fan
smaller fan
main fan
light
12. Remote Control Operation.