WPS-100 Smart WiFi Wall Plug Installation Guide
WARNING: RISK OF ELECTRIC SHOCK This product installation requires handling 120 volt wiring. Follow each step carefully. If any concerns handling wiring, hire a qualified electrician. Ensure all work meets local and federal regulations.
Simple DIY Setup • Download the Craftmade Smart app. • Add your Craftmade Smart Plug the Craftmade Smart app.
Compatibility Requirements • Rating 120V AC 60Hz. • Wi-Fi 802.11 b/g/n @ 2.4 GHZ is required. • Works with compatible LED bulbs.
Alternate Connection Procedure Smart mode networking Preconditions: Connect to the load, reset state long press plug 10S to reset the load) 1.
Alternate Connection Procedure (continued) 2.
Alternate Connection Procedure (continued) 3. Connect to Wi-Fi, enter the password of Wi-Fi account, and click “Next”.
Alternate Connection Procedure (continued) 4. The network is being distributed.
Alternate Connection Procedure (continued) 5. Your device should show successfully added.
Alternate Connection Procedure (continued) 6. Enter the device control page.
Additional Information and Warnings FCC Compliance Statement Compliance Notice: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are design ed to provide reasonable protection against harmful interference in a residential installation.
CAN ICES-3 (B)/NMB-3(B) Model: model no WPS-100 This device contains license-exempt transmitter(s)/receiver(s) that comply with Innovation, Science and Economic Development Canada’s license-exempt RSS(s). Operation is subject to the following two conditions: 1. This device may not cause interference. 2. This device must accept any interference, including interference that may cause undesired operation of the device.
CAUTION: FOR CONTROL OF INCANDESCENT OR LED LUMINAIRES ONLY.
RF Exposure information: This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. In order to avoid the possibility of exceeding the FCC radio frequency exposure limits, human proximity to the antenna shall not be less than 8 inches during normal operation. RF Exposure statement: This equipment complies with IC RSS-102 radiation exposure limits set forth for an uncontrolled environment.
CAUTION – To reduce the risk of overheating and possible damage to other equipment. Do not install to control a receptacle or motor-operated appliance or transformer-suppled appliance.
