Installation Guide

a. Tuck wires back into the
electrical outlet box.
b. Attach fixture to mounting
bracket. Tighten cap nuts to
hold fixture to the ceiling.
c. Remove roof assembly screws.
Remove roof and insert bulb.
Reattach roof.
(See illustrations below.)
Mount Pendant to Ceiling
Crossbar
Fixture Screws
Bulb Installation
Connect t
o
Black Sourc
e
W
ir
e
Connect t
o
White Sourc
e
Wire
1
2
3
Ground Screw
Black Source Wire
Wire Nuts
Ground Wires
White Source Wire
Wire Pendant to Outlet
Interior/Exterior
Lighting
Cap Nut
Cap Nut
a. Take the source wires and the ground wire from the
pendant and weave them through the chain (going in and
out of every other piece of chain - see the pendant illustration below).
Twist together white source wire with white labeled fixture wire. Next,
twist together black source wire with black labeled fixture wire. Use
wire nuts (which should be included in your outlet box) to secure
connections.
b. Connect fixture ground wire (if provided) and outlet ground wire
to ground screw on crossbar as shown in diagrams, by first wrapping
outlet ground wire around the ground screw, tighten ground screw,
leaving approximately 2 to 3 inches in excess beyond ground screw.
Finally, twist together outlet ground wire with fixture ground wire
using wire nuts.
a. For two screw and
multiple screw assembly
roofs, remove assembly
screws on roof (or
underneath roof) and
insert bulb(s). Reattach
roof (see figure 1).
b. For fixtures with an
open bottom, simply
install the bulbs
through the opening
in the bottom of the
fixture (see figure 2).
Figure 2
Open Bottom
Roof
Assembly
Screws
Figure 1
Two Screw Assembly
Mounting
Screws
Crossbar
Electrical
Box
Center
Screw
a. Tuck wires back into the
electrical box.
b. Screw collar loop onto center screw
and screw center screw into crossbar.
c. Place the canopy flush with the
ceiling and screw the collar ring onto
the collar loop.
E2 E3