Installation Guide

Prepare Footing & Insert Anchor Bolts
a. To ensure adequate support, the concrete footing used to
mount this lamp post should be at least 12" X 12" and 16"
deep. Consult local electrical codes for required footing depth, wiring
type and other restrictions. Level forms for footing using a Builder's
Level. Mix concrete so that it is stiff. Concrete should be poured
around the conduit carrying power to the fixture (see Diagram A).
b. Wrap Base in plastic bag, as shown in Diagram B, to prevent concrete
form getting onto base. Thread hex nut on anchor bolts completely,
as shown in Diagram B. Make small holes in bottom of plastic bag to
allow each anchor bolts and wiring to pass through base.
c. Insert the supplied anchor bolts through plastic bag into the post base
and secure with cap nuts as shown in Diagram B. Be careful not to
overtighten hex nuts as excess pressure may cause damage to post
base. Use tape to patch any holes in bag.
d. Set the base and anchor bolt assembly into the wet concrete, as shown
in Diagram C, by gently wiggling the base while pressing downward
until the bottom of the base is flush with the concrete. Make certain
that concrete has completely covered the anchor bolts.
e. Check the base to see that it is level in both directions, as shown in
Diagram D.
f. Leave base (wrapped in plastic bag) and anchor bolt assembly attached
until concrete has cured. Finish concrete.
g. To install post on a wood deck use 3/8" wood screws (not included).
Hex Nut
Cap Nut
Anchor Bolt
Base
Diagram B
Plastic
Bag
Diagram D
Builder's Level
Diagram A
Conduit
16"
12"
100"
excess wire
Diagram C
Base
Anchor
Bolt
Wet
Concrete
a. Assemble post by attaching lower post section to
upper post section by threading break knuckle into
upper and lower post sections (as shown).
Post Assembly
c. With post laying on its side, thread supply wire through post
allowing excess wire at top to wire fixture head.
Supply Wire
b. For post with fixture sold separately, thread
3" post cup into upper post section.
Break
Knuckle
Upper
Post
Section
Post Base
Lower
Post
Section
Fixture Head
Fixture
Arm
Fixture Wires
Screws
Post Assembly for Multiple Fixture Heads
a. To prepare arm
assembly for multiple
fixture lamp posts,
attach arms to head as
shown in diagram. Be
sure to thread wires
from fixture arm into
fixture head before
tightening screws.
3" Post
Cup
Supply
Wire
Post
Section
Post
Base