Manual

PROGRAMMING
NOTICE: If this Secuhty^^garage door opener is operated with a non-rotiing code transmitter, the technicai
measure in the receiver of the garage door opener, which provides security against code-theft devices, wiii be
circumvented. The owner of the copyright in the garage door opener does not authorize the purchaser or
supplier of the non-rotting code transmitter to circumvent that technical measure.
Your garage door opener has already been programmed at the factory to operate with your hand-held remote
control. The door will open and close when you press the large push button.
Below are instructions for programming your opener to operate with additional Security+® remote controls.
To Add or Reprogram a Hand-held Remote Control
USING THE “LEARN” BUTTON
1. Press and release the “learn”
button on the motor unit. The learn
indicator light will glow steadily for
30 seconds.
3. Release the button when the motor
unit lights blink. It has learned the
code. If light bulbs are not installed,
two clicks will be heard.
2. Within 30 seconds, press and hold
the button on the hand-held
remote* that you wish to operate
your garage door.
To Erase All Codes From Motor
Unit Memory
To deactivate any unwanted remote,
first erase all codes:
Press and hold the “learn” button on
motor unit until the learn indicator
light goes out (approximately 6 seconds). All previous
codes are now erased. Reprogram each remote or
keyless entry you wish to use.
*3-Function Remotes
If provided with your garage door opener, the large
button is factory programmed to operate it. Additional
buttons on any
Security*® 3-Function
remote or compact
remote can be
programmed to operate
other Security*® garage
door openers.
35