Owner`s manual

caster/caster foot assembly
1. Turn the dust drum upside down on the floor.
2. Insert the caster feet into the bottom of drum, as
shown (4 places).
3. Push on the caster foot until the foot is flush with
bottom of the dust drum. Installation of caster feet
may require taps with a hammer tot complete seating.
CASTER
CASTER
PIN
4. Insert the caster stem into the socket of the caster
foot, as shown (4 places).
5. Push on the caster until the ball on the castor stem is
inserted all the way into the socket. You will be able
to feel the ball snap into the socket and the caster will
swivel easily when positioning is correct.
6 Turn the drum updght.
NOTE: Ifthe casters are noisy, you may put a drop of oil
CASTER_ :_
FOOT
HOLE
DUST DRUM__
on the roller shaft to make them quieter.
PERFORMANCE INDICATOR
The performance indicator senses air flow through the
vacuum cleaner,
BLOWING
PORT
ON-OFF
SWITCH
POWER CORD
When the vac is not running the green indicator is not
visible.
Under normal operating conditions, the green indicator
will rise from the control panel recess, indicating the
system is functioning properly.
NOTE: The use of certain accessories that restrict the
airflow into the wet/dry vac, such as the crevice tool, may
cause the performance indicator to drop out of sight.
The vacuum cleaner and filter are still working and can
continue to be used.
When the filter is clean and the hose and nozzle unob-
structed the Green Performance Indicator will be clearly
visible.
When filter is extremely dirfy orthe hose is clogged, the
indicator will drop down out of sight.
When this occurs check the hose and nozzle for obst ruc-
tions, if these are clear, set switch to "OFF", unplug the
vac, remove and clean or replace filter.
When picking up water or other liquids (refer to warnings
on page 2 of this manual) and the nozzle or hose end is
completely under water, the indicator will also drop out
of sight. In this situation no air can flow, however, the
system is functioning and pickup will continue.
AREA
LID HANDLE
DUST DRUM-
CASTERS
DRAIN
PERFORMANCE INDICATOR
VARIABLE SPEED
SLIDE CONTROL
)RMANCE INDICATOR
_VACUUM
PORT
L
\
\
\ RECTANGULAR
\\ NOZZLE
VARIABLE SPEED
3-POSITION SWITCH
"Hi" position will operate vac at full power.
"OFF" turns vac off.
"VAR" allows you to run vac at different power settings
by using the VARIABLE SPEED CONTROL.
This allows you to "Dial Down" the suction of the vac for
use on carpet or curtains or whenever you need less
than full power.
6