Owner`s manual

Assembly
_k WARNING
Plugging in saw during assembly
could result in electrical shock, or
severe cuts from contact with spin-
ning blade.
Do not plug in saw at any time dur-
ing assembly.
Plug in saw only when it is to be
used.
Assembly Steps
It is important for your safety and to get
accurate cuts that you put the saw together
according to these instructions.
Fol!ow these steps in order.
Assembling steel legs
For easy assembly it is recommended to fin-
ger tighten all screws, lockwashers, and hex
nuts until the legset is fully assembled. Then
go back and tighten all nuts securely.
From among the loose parts, find the follow-
ing Hardware:
24 Truss Head Screws, 1/4-20 x 5/8
24 Lockwashers, 1/4-External
24 Hex Nuts, !/4-20
8 Hex Nuts, 3/8 - 16
4 Leveling Feet
1. Insert three truss head screws through the
three holes near the top of one Leg. Place the
Side Stiffener up to the Leg, as shown, so
that the three screws line up with the holes in
the Side Stiffeners marked with an "X" in
the illustration.
2. Place a lockwasher and hex nut on each
screw and finger tighten the hex nut.
3. Following the same procedure as above,
continue to fasten together the remaining
Legs, Side Stiffeners, and Front/Rear
Stiffeners as illustrated.
4. Set stand upright and securely tighten all
nuts.
5. Install one 3/8-16 hex nut completely onto
each of the leveling feet. Insert one leveling
foot through hole in bottom of each leg and
install a 3/8-16 hex nut.
6. To level steel legs, loosen nut on inside of
leg and turn nut on outside to raise or lower
feet. Adjust all four levelers if necessary, and
then tighten nuts on inside of leg.
Note: These levelers" are not intended for
height adjustment.
For model 113.196421 only
From among the loose parts, find the follow-
ing hardware:
16 Truss Head Screws 1/4-20 x 5/8
16 Lockwashers, 1/4" external
16 Hex Nuts, 1/4 -20
!. Attach the lower leg stifeners to the steel
legs using two (2) screws, lockwasher and
hex nuts on each end. For the short side of
stand, use the inside holes in the stiffeners.
For the long side, use the outside holes.
2. Tighten all nuts securely.
X = Location of Truss Head Screws
Front/Rear
Stiffener
Side Truss Head
Stiffener Screws
3/8" Hex Nuts
Leveling Foot
15