Owner`s manual

Adjustments
Arm Lock Adjusting Wheel
Miter/Arm
Lock Lever
With the arm at an "unindexed" position and
the miter lock applied, the locking action
should feel tight and secure.
Considerable effort should be required to
move the ann back towards 0 °. Its is "always
possible to force the arm because of the
leverage advantage the long arm provides.
However, the arm should resist moving
when a reasonable amount of force is
applied.
To check follow these steps:
1. Pull miter/arm lock forward to unlock and
rotate ann to approximately 30° left or right.
2. Lock miter/arm lock by pushfng handle
toward rear of saw.
3. Apply pressure as shown above.
4. If the arm moves easily:
a. Unlock miter lock.
b. Locate the adjusting wheel as shown.
c. Turn wheel clockwise to tighten,
counterclockwise to loosen.
5 Repeat steps 1, 2, 3 above and readjust as
necessary.
Arm Lock
Adjusting Wheel
19