Owner`s manual

Adjustments
Yoke Clamp Adjustment
To check the yoke clamp adjustment follow
these steps:
1. Pull the yoke lock handle towards the
front of saw to unlock yoke. Pull forward on
the yoke index lever (on the left side of car-
riage) to disengage index pin.
2. Swivel the motor halfway between the
crosscutting and rip position so the index pin
is not engaged.
3. Lock the yoke lock handle.
4. Grasp the motor with both hands and try
to swivel it back into the crosscut position. It
should not move.
5_
If it does move tbllow these steps:
a. Rein,we arm cap.
b. Remove carriage stop screw and lock-
washer with a 1/4 inch hex-L wrench.
c. Grasp the carriage assembly, move it
careful] v off the end of radial ann, hold-
ing it parallel to the radial arm until all
carriage bearings are free of their tracks.
d. Rest lhe motor and carriage assembly
on saw frame.
e. Set yoke lock handle at unlocked posi-
tion. Tighten nut with 15/16" x_,renctl,
until lock handle locks mid-way between
the two legs of the yoke.
f. ltold the motor and carriage assembly
parallel to radial arm and starl the rear
bearings onto the tracks. Continue to hold
the assembly parallel to the tracks unlil
the forward bearings are on the tracks.
g. Slide the carriage rearward on the radi
a[ arn-t tmlld install the carriage stop screw
and lockwashcr.
h. Instal! arm cap.
i. Rcpcul steps 1 4. Read usl if nccc_<s',try.
Lock Washer
Carriage Stop
Screw
15/16" Wrench
I
Yoke Lock Handle
Arm Cap
Screw
Hex "L" Wrench
(1i44nch)
/
/
2O