Operator`s manual

17.Lay a framing squareon thefront table
with the long edge along the back of the table
and the short edge alongside the motor arbor,
as before.
18. Move the framing square toward the
motor arbor until the arbor and square touch.
19. Move the motor arbor back and forth
along the radial arm. Do not move the square.
20. If the motor arbor just touches the edge of
the square at all points, go to step 21, or
If the motor arbor moves away from the edge
of the square or tries to "walk" on top of it, go
back to step 12 and repeat.
21. Set miter indicator on 0° position as
shown. (Figure 55)
22. Lock the rip lock, put the spacer, fence
and rear table back in place, lock the table
clamp, and go to the next section.
i/<J J
Fig. 55
Positioning Rear Table Boards
and Fence
1. Position the ripfence next to the front table
as shown.
Mounting Table ClamPs
The following parts are used in mounting the
table clamps:
A Thumbscrews ..................... 2
B Square Nuts ...................... 2
C Cup Washer ...................... 2
D Clamp Bracket ................... 2
C
\
1. Drop square nut in slot at top of clamp
bracket.
2. Turn thumbscrew clockwise until the point
comes approximately 1/2" out other end.
3. Tilt clamp bracket forward and snap in
place in rectangular shaped hole at back of
table support. (Figure 57)
4. Attach cup washer by holding washer
against rear table. Turn thumbscrew clockwise
until it snaps into small hole in cup washer.
Fig. 57
2. Next drop in the table spacer and then the
rear table.
Rear Table
Table Spacer/Rip Fence Front Table
c t ,l,q/ / j
5. Repeat steps I through 4 with the other table
clamp.
Squaring Blade to Table
for Crosscutting
These steps are necessary so that your blade
will be perpendicular to the table and cuts
will be accurate. If this is not done correctly,
your cuts will have a slight bevel angle.
Fig. 56 23