Operator`s manual

Miter Lock Handle
Fig. 131 - Miter Lock - Unlocked
2. With a 3/16 inch hex "L" wrench find the
1/4-20 hex socket cap screw through the hole in
the rear of the arm cover. To tighten turn the
wrench clockwise approximately 1/4 turn.
(Figure 132)
@
• @
Rip Lock !............... ;
The tip lock locks the carriage [n:any_-pos!tion
along the length of the arm. Ifit_'az_'a_
can be easily moved by pushing_and-pulling
on the yoke handle when the rip lock is in the
locked position an adjustment is required.
1. Hold the rip lock in the unlocked position
and with a 7/16 inch wrench tighten the 1/4-20
hex lock nut 1/4 turn. (Figure 133)
Arm Track
[_Sprin_ Locknut
___ Spacer
Rip Lock / "N
Lever Cam Carriage
Bolt
Fig. 133 - Location of Hex Lock Nut
2. Lock the rip lock and try again to move the
carriage. Make additional adjustments if
necessary.
3. Place the rip lock in the unlocked position
and move the carriage back and forth from
stop to stop. If the carriage is difficult to
move at any point or you can feel the rl)) lock
dragging on the track the adjustment is too
tight. Loosen the hex nut one half the
amount of the last adjustment and try again.
Fig. 132- Location of Hex Socket Cap Screw
3. Lock the miter lock and try again to move
the arm. Readjust if necessary.
4. If it becomes extremely difficult to push
the miter lock into the locked position too
much adjustment has been made. Turn the
wrench counterclockwise one half the
amount of the last adjustment and try again
to lock the arm.
65