Owner`s manual

ASSEMBLING LEG SET
From the loose parts find the following hardware:
4 Legs
4 Upper Stiffeners
4 Lower Stiffeners
From loose parts bag #498 find
hardware:
40 Truss Head Bolts 1/4-20 x 1/2
40 Lock Washers Ext. 1/4
40 Hex Nuts 1/4-20
4 Leveling Feet
8 Hex Nuts 1/2-13
the following
Assemble the Leg Set as Follows
1. Attach the four (4) legs to the four (4) upper
stiffeners as shown. Three (3) bolts, washers,
and nuts are required to fasten each end of upper
stiffener to a leg. Hand tighten hex nuts.
,
,
Attach the four (4) lower stiffeners to the legs.
Two (2) bolts, washers and nuts are required to
hold each end of a lower stiffener in place. Hand
tighten hex nuts.
Attach four (4) leveling feet to bottom of each leg
as illustrated. Hand tighten hex nuts.
4. Put leg set in area intended for use of saw. With a
7/16" wrench or socket, securely tighten all
bolts. Adjust leveling feet.
WARNING: TO AVOID INJURY FROM UNEXPECT-
ED SAW OR WORK MOVEMENT, LEVELING FEET
MUST BE ADJUSTED SO THAT SAW DOES NOT
ROCK. TO AVOID UNEXPECTED CARRIAGE MOVE-
MENT, ADJUST LEVELING FEET SO THAT THE
ARM SLOPES SLIGHTLY DOWNWARD TO THE
REAR.
To adjust leveling feet so the saw will set properly:
a. Move saw to desired location.
b. With 3/4" wrench loosen bottom nut.
c. Back off top nut by hand.
d. Raise or lower foot by adjusting bottom nut using
3/4" wrench.
e. Snug top nut against inside of leg by hand.
f. Adjust all four feet as necessary, then tighten all
four bottom nuts using a 3/4" wrench.
LEG
HEX NUTS
LEVELING FOOT
12
MOUNTING SAW
1,
From loose parts bag #498, find the following
hardware:
4 - Truss Head Bolts 1/4-20 x 1/2
4- Lockwashers External 1/4
4 - Hex Nuts 1/4-20
2. Place saw on leg set so that holes in bottom of
saw line up with holes in top of leg set.
3. Install bolts, Iockwashers, and nuts as shown.
Tighten securely using a 7/16" wrench or socket.
TRUSS HEAD BOLT
SAW BASE
",,,
I
LOOKWASHER_
HEX NUT
,1!+!1
o o o i