Owner`s manual
MOUNTING MOTOR
1. Remove the blade guard. Locate the arbor
wrenches and remove the blade.
CAUTION: Do not attempt to mount the motor until
the blade guard and blade have been removed.
2. Elevate the arm approximately 2 inches to remove
shipping pad.
3. Using a 3/4 socket remove 1/2-13 lock nut and
1/2" flat washer from motor pivot support.
4. Slide motor on motor pivot support until motor is
firmly seated on support as illustrated.
5. Re-install the flat washer and lock nut and
tighten until snug with 3/4" socket.
WARNING: DO NOT OVER TIGHTEN LOCKNUT.
To insure proper function of the bevel lock, move the
bevel lock handle while tightening the Iocknut.
Adjust according to Step 6.
l/'f ................._ ,
I
J
6. Push bevel lock handle to left side to lock.
NOTE: Bevel lock handle should not contact extreme
left side of yoke when in locked position. If bevel
lock handle is permitted to contact yoke the following
adjustment is required.
a. Unlock bevel lock handle and tighten motor
Iocknut. Recheck bevel lock handle position (see
illustration).
b. Repeat adjustment if necessary. Do not over
tighten or motor will not index.
\
ALIGNMENT PROCEDURE
IMPORTANT: In order to obtain maximum cutting
accuracy and safety, the following six steps must be
carefully followed. Become thoroughly familiar with
these steps so that you can always maintain your
saw in proper alignment. The accuracy of each
adjustment is always dependent upon the accuracy
of the preceeding adjustment.
Be sure to align the saw in the exact sequence
described to insure proper alignment and cutting
accuracy.
After following the 6 step assembly and alignment
procedu re and the Basic Saw operation section refer
to Trouble Shooting section if any difficulty is
experienced when performing any sawing operation.
STEP ONE
Adjusting Column Tube in Column Support
1. Elevate and then lower the arm.
(a) If the column binds and elevation is difficult,
loosen the four (4) bolts, with 9/16 socket and
O
©
extension, located through the holes in the
rear column support cover until movement is
smooth but firm.
14