Operator`s manual

There are flve pre-set bevel angles at -90 °,
-45 °, 0°, 45 °, nnd 90 °. To unlock the bgvel
lock when the blade is at one of these angles,
move the bevel lock all the way to the right
and turn the motor while holding the lock in
this position.
Swivel Lock
The swivel lock is used to hold the blade in
the crosscut, in-rip, or out-rip positions, and
to position the blade for molding or edging.
To unlock the swivel lock, stand facing the
saw handle and pull the swivel lock toward
you. (Figure 30)
Frg. 30 - Swivel Lock - Unlocked
To lock the swivel lock, stand facing the saw
handle and push the swivel lock away from
you. (Figure 31)
s_d_,el lock when the motor ig in one o[ these
positions, stand facing the saw handle, pull
the swivel lock all the way toward you, and
turn the motor as yon hold the lock in this
position.
Rip Lock
The rip lock is used to hold the motor and
blade at a fixed position along the radial arm.
It is used during ripping to hold the blade a
desired distance from the fence while the
workpiece is fed through. It is used before
and after each crosscut to keep the blade
from moving forward on its own.
To unlock the rip lock, pull the handle toward
the front of the arm. (Figure 32)
Fig, 32- Rip Lock - Unlocked
To lock the rip lock, push the handle toward
the rear of the ann. (Figure 33)
Fig. 31 - Swivel Lock - Locked
The crosscut, in-rip, and out-rip positions of
the blade are pre-set positions. To unlock the
Fig. 33 - Rip Lock - Locked
15