Owner`s manual

maintenance

WARNING FOR YOUR OWN SAFETY, TURN

SW_TCH "OFF" AND REMOVE PLUG FROM POWER

SOURCE OUTLET BEFORE MAINTAINRNG OR LUB-

RICATaNG YOUR DRILL PRESS.

Frequently blow out any dust that may accumulate in-

side the motor.

A coat of furniture-type paste wax applied to the table

and column will help to keep the surfaces clean.

WARNING: TO AVORD SHOCK OR F_RE HAZARD,

IF THE POWER CORD nS WORN OR CUT, OR DAM-

AGED IN ANY WAY, HAVE IT REPLACED AM-

MEDIATELY.

lubrication

All of the BALL BEARINGS are packed with grease at

the factory. They require no further lubrication.

Periodically lubricate the gear and rack, table elevation

mechanism, the SPLINES (grooves) in the spindle, and

the RACK (teeth of the quill). See "Getting to Know

Your Drill Press".

MOTORCORD

POWER CORD

"___,

Sesrs

Drill Bits ......................... See Catalog

Hold-Down and Guide .................. 9-2457

Drill Press Vises ................... See Catalog

Rotary Table ...................... See Catalog

Drill Press Mortising Kit ............. See Catalog

5 pc. Stop Collar Set ............... See Catalog

Recommends the Following Accessories

15 piece Drum Sanding Kit .......... See Catalog "_

Clamping Kit See Catalog "_ -_-

Mortising Chisels and Bits ........... See Catalog _ o

Sanding Drums ................ 9-2497 -- 9-2498 E

Buffing Wheels up to 4" dia, max. See Catalog o co

Power Tool Know-How Handbook ........ 9-29117 t,-

Sears may recommend other accessories not listed in the manual.

See your nearest Sears stere or Catalog department for other accessories_

Do not use any accessory unless you have received and read complete instructions for its use.