Owner`s manual

assembly

TABLE

LOCK

2. Remove protective covering from table and discard. /

Place table in table support and tighten table lock TABLE

(located under table) by hand.

TABLE /

SUPPORT

iNSTALLING THE HEAD

CAUTION: The head assembly weighs about 55

pounds. Carefully lift head.

1. Remove protective bag from head assembly and

discard. Carefully lift head above column tube and

slide it onto column into position. Align head with

table and base.

HEAD

2. Locate two (2)3/8-16xl/2 set screws among loose

parts bag.

3. Install set screws m right side of head to lock head

into position, and tighten with 3/16" HEX "L" wrench.

HEAD

LOCKS

HEAD

MOTOR BRACKET

5/16-18

HEXHEAD

BOLTS

MOUNTING MOTOR

1. Locate four (4) 5/16-18x3/4 hex head bolts, eight

(8) flat washers, and four (4) hex nuts amoung loose MOTORBASE

parts.

2. Install hex head bolts through motor bracket on

head.

3. Place motor in position so motor base slots line up

with motor brackets slots. Install flat washers and

hex nuts as illustrated.

4. Motor shaft should be incenter of slot in lower guard.

5/16 HEX FLAT

HEAD NUT WASHER