Owner`s manual

INSTALLING MOTOR PULLEY

1. Loosen set screw in motor pulley using 1/8" HEX

"L" wrench,

2, Slide pulleyonto motor shaft. Line up the flat surface

on the motor shaft with the set screw in pulley.

3. Make sure the pulley does not rest on the lower

guard.

MOTOR PULLEY

SET SCREW ___

FLAT SURFACE

iNSTALLiNG AND TENSIONING BELT

WARNING: To avoid injury due to accidental start-

ing always turn Drill Press off and remove switch

key before making belt adjustments.

1. Place a straight edge such as a piece of wood,

metal, or framing square across tht top of pulleys.

2. Move the motor upwards until the pulleys are in line.

Tighten the motor mount nuts using 1/2 inch wrench.

NOTE: To avoid rattles or other noise, motor frame

must not touch lower belt guard.

3. Release Belt Tension Lock handles located on each

side of Drill Press head.

LEVER

SHAFT

i1__- --BELT

TENSION

LOCK

HANDLE

BELT

;tON

HANDLE

4. Locate one (1) tension rod and one (1) knob among

base parts.

5. Screw the knob on the rod, then screw the rod into

the shaft.

LOWER

BELT

GUARD

STRAIGHT EDGE

6. Loosen Belt Tension handle by turning clockwise,