Owner`s manual

WARNIlNG: TO AVOID iNJURY DUE; TO
ACCIDENTAL START. TURN SWITCH "OFF" AND
REMOVE PLUG FROM POWER SOURCE O UTLET.
2, MAKE SURE THE BLADE IS ALL THE WAY UP
AND SQUARE WtTH THE TABLE
3 Posit_on SPREADER SUPPORT on rod until it Js
even w_h the cod of the rod.
BLADE S©UARE
W_TH TABLE
4 Assemble the Zt8 in long setscrews nuts
_ockwashers and washers to the SPREADER
SUPPORT BRACKET and s_ip the nuts into the
slot m tr_e spreader support,
5, Finger tighten ONLY THE HEX NUTS,
6 Lay a piece of fiat straight wood and a square on
saw table and rotate the SPREADER SUPPORT
unti_ the bracket is a_igned with square.
7, MAKE SURE END OF SUPPORT, BRACKET
AND ROD ARE EVEN.., using a 1/8 in_ setscrew
wrench, TIGHTEN THE SET_CREWS ONLY.
ENDS OF SUPPORT
AND BRACKET TO
BE EVEN WITH
END OF ROD
/
TIGHTEN
SETSCREW ONLY
24