Owner's Manual

3. Operate the tilt lock handle (COUNTERCLOCKWISE)
to loosen the tilt clamp screw.
4. NOTE: Handle is spring loaded for engagement with
screw head -. must be pushed inward for disengagement
whenever necessary to obtain a new grip on screw head.
I "1
5. Rotate tilt handwheel CLOCKWISE a few turns to tilt
blade. Now rotate handwheel COUNTERCLOCKWISE
until it stops. Blade should now be square with table
and pointer should point to "0".
TILT HANDWHEEL
I TILT,/POINI"-ER_"
If blade is SQUARE to table;
A. Check peinter
IF POINTER DOES NOT point to the "O" mark on the
bevel scale;
A. Remove Elevation Handwheel.
B. Loosen screw and adjust pointer ... using medium
screwdriver.
C. Install Elevation Handwheel.
POINTER
I./ i '
_OINTER AT
"0" POSITION
\
SCALE ADJUSTING
SCREW
If blade is NOT SQUARE to table.., the 90 ° LIMIT STOP
must be ADJUS-]-ED.
1. Using a medium size screwdriver, loosen BOTH
setscrews in 90 ° STOP COLLAR.
NOTE: If you can't reach the setscrews, turn the TILT
HANDWHEEL slightly.
2. ROTATE the STOP COLLAR moving it all the way to
the end of T!LT SCREW. (to the right}.
3. TILT blade RIGHT or LEFT ... checking with your
square until blade is square to table.
4. ROTATE STOP COLLAR moving it to the right until it
stops... TIGHTEN the setscrews.
5. Check POINTER. If it DOES NOT point to the "'0""
mark on the bevel scale...
A. Remove Elevation Handwheel.
B. Loosen screw and adjust pointer ... using medium
screwdriver.
C. Install Elevation Handwheel.
45 ° STOP COLLAR
4
TILT
HANDWHEEL
STOP COLLAR
33