Specifications

2. Insert four (4) 5/16-18xl 114 in. long screws through
hole in each Extension.
3. Position extension against table so screws extend
through hole in table.
4. Install flat washers, Iockwashers, and nuts on the
screws...DO NOT TIGHTEN.
!
5. Line up the rear edge of extension with the rear edge of
the table and top surface of the extension with the top
of the table at the spots marked "X" in the drawing. Use
a combination square to line-up these edges. SLIGHTLY
TIGHTEN nuts with a 1/2" wrench.
6. If the side extension is lower in the center than each
end, loosen the center two screws. Using a "C" clamp
(not provided), raise the side of the extension until it is
even with the table surface as shown. Firmly tighten
nuts.
7. Repeat steps 2 thru 6 to install the other extension.
"C" CLAMP
CHECK WITH SQUARE
AT 2 PLACES
MARKED WiTH "X"
I I
MOUNTING SWITCH
1. From among loose parts findthe following:
*2 Hex Head Screw 5/16-18 x 3/4
*2 Flat washers. 21/64 x 5/8 x 1/16
*2 External Lockwashers, 5/16
*2 Hex Nuts, 5/16-18
5116-18x 3/4
HEX HEAD SCREW21164 IN WASHER
5/16 iN 5/16 IN EXTERNAL
HE)( NUT LOCK WASHER
Items marked with an asterisk(*) are shown actual size.
13