Specifications

assembly
2. Position front guide bar upside down as illustrated.
3. Insert two 3/4 inch screws through two flat washers
then through holes in switch.
4. Insert screws through holesfive and six infrontfence
guide bar as illustrated.
5. Install two Iockwasher and nuts. Tighten nuts.
JAM NUT
5/16-18
1 LOCKWASHER
_/" 7 5TH HOLE
J _'\ _ FRONT FENCE
6TH HOLE ',- \_.__-_ GUIDE BAR
(UPSIDE DOWN)
%%"_""- W ASH E R
HEX HEAD SCREW
5/16-18 x 3/4 IN.
iNSTALLiNG RIGHT FRONT RIP FENCE
GUIDE BAR
1. From among the loose parts, find the followinghard-
ware:
*2 Hex Head Screws, 5/16-18x 1-3/4
"1 Hex Head Screws, 5/16-18x 3/4
*4 Lockwashers, 5/16 External Type
*4 Hex Nuts 5/16-18
"3 Spacers, 3/4 diameterx 1/2 long
"1 Hex Head Screw 5/16-18 x 1-1/4
*2 Flat Washers 5/8 x 1/16
1 Bracket
Items marked with an asterik (*) are shown actual size.
5/16-18 x 1-t/4 IN
HEX HEAD SCREW 5/16 IN EXTERNAL
LOCK WASHER
5/16 IN
HEX NUT
HEX HD. SCREW 5/16-18 x 3/4 IN
HEX HEAD SCREW
5/8 x 1/16 IN WASHER 314IN. DIA. X 112IN.
SPACER
=
BRACKET
2. Put the bracket against the right edge of the right "_ -- ---"--_
extension so the bracket is lined up with the FIRST
hole near the front of the extension. Insert a 3/4 long
screw through a flat washer, through top hole in the
bracket, and throughthe FIRST hole inthe extension.
Installa lockwasherand nuton thescrew, Tightenthe T_,,_ _, _/_ _ 1WASHER
nut only slightly.
EXTERNAL
LOCKWASHER HEX HEAD
SCREW
5/16-18 x 3/4 IN
NOTE: The various holes in the Bar allowthem to be
positionedon the saw and also makes them adapt-
able to other models.
3. Insert a 1-314 inch long screw through the second
holefrom LEFT Inthe Front Bar.
5. Turn front bar perpendicular and insert boltthrough
center hole in middleof saw table as illustrated.Install
lockwasher and nut. DON'T SCREW NUT ON ALL
THE 'NAY, just get the nut started on the screw.
6. Rotate guide bar parallel to table.
t
_'CENTER HOLE :
'\ IN TABLE
2ND HOLE
IN BAR
;P
_f
14