Specifications

ADJUSTmNG RiP SCALE POINTER
1. Turn Elevation Handwheel clockwise untilblade isup
as high as it will go.
IMPORTANT: BLADE must be SQUARE (90°) to
TABLE, in order to ALIGN Rip Scale.
2. Position Fence on right side of sawblade so that it
touches the sides of the teeth, tighten Lock Handle.
3. Loosen screw holding the Pointer, adjust so that it
points to "0" on the Rip Scale, tighten screw.
NOTE: Ityou cannot adjust Pointer so that it points to
"0", loosen the screws holding the Front Guide Bar
and move the Guide Bar.
LOCK HANDLE F
\
\ \
\ \
INSTALLING BLADE GUARD
1. From among the loose parts, find:
"2 Hex Head Screws, 1/4-20 x 5/8 1/4-20
*3 Hex Head Screws, 5/16-18 x 5/8 HEX NUT
*2 Hex Head Screws, 5/16-18 x 1
*2 Hex Nuts, 1/4-20 k--J_'_
"2 Lockwashers, 1/4 External Type
*2 Lockwashers, 5/16 External Type
"1 Thumbscrew
1 Blade Guard Support 5/16 IN.
1 Spreader Support EXTERNAL
1 Spreader Rod LOCKWASHER
Items marked with an asterik (*) are shown actual size.
1/4-20 X 5/8 IN.
HEX HD. SCREW
5/16-18 X5/8 IN.
HEX HD. SCREW
5/16-18 X 1 IN.
HEX HD. SCREW
©
1/4 IN.
EXTERNAL
LOCKWASHER
BLADE GUARD
SUPPPORT
THUMBSCREW
LI
SPREADER ROD
SPREADER SUPPORT
2. Before installingthe BladeGuard, you mustcheckthe
heeling adjustment (parallelism ofsawblade to Miter
Gauge Groove). The procedurefor makingthischeck
and adjusting it are found in the "ADJUSTMENTS"
section ofthis manual. Refer to "Heeling Adjustment
or Parallelism ofSaw Blade to Miter Gauge Groove."
WARNING: The blade must be parallel to Miter
Gauge Groove. Mlsaligned blades could bind on
workplace. Workplace could suddenly kick back.
You could be cut or hit.
3. Lower the blade.
4. Screw the Motor Base Clamp Screws part way into
cradle. Screw the 5/16-18 x 5/8 inch Hex Hd. screw
intothe Blade Guard support.
5. Attach Blade Guard Support. DO NOT TIGHTEN
SCREWS.
19