Specifications

assembly
6. Insert Spreader Rod into Spreader Support untilpin
fits into notch. Insert Thumbscrew and tighten it.
TH LIMB SCREW
\
SPREADER _
ROD
\
\
FLAT
SURFACE
(INTO SUPPORT)
II
SPREADER
SUPPORT
7. Slide Spreader Rod into Blade Guard Support until
end of Rod is even with edge of Support, Tighten
Hex Head Screw in Support.
8. Attach Spreader to Spreader Support so that the
edge of the Spreader is ever_ with the edge of the
Spreader Support. Tighten screws.
9. Raise Anti-Kickback Pawls (hold in place with a set-
screwwrench-see below). AlignSpreaderSQUARE
to table.
Tighten both 5/16-18 x I inch Hex Head Screws.
1/4-20 HE](
HD. SCREW
1/4 IN. LOCKWASHER
1!4-20 HEX NUT
EVEN WITH SPREADER
SUPPORT EDGE
END OF ROD
EVEN WITH EDGE
OF SUPPORT
J
5/16-18 X 1 IN.
HEX HD. SCREWS
10.Raise blade all the way up, make sure it is square
with table.
11.Raise Blade Guard. Lift up both Anti-Kickback
Pawls. Insert one ofthe Setscrew Wrenches in the
notches to hold the Pawls out of the way.
12.Lay blade of square or other straightedge alongside
of blade.
13.Loosen Hex Head Screw in Guard Support and
move Spreader so that it touches blade of square.
Tighten screw.
and approximately in line with the sawblade. The
Spreader requires further adjustment to alignit PAR-
ALLEL to the blade and in the MIDDLE of the cut
(KERF) made by the sawblade.
SCREW