Specifications

assembty
5. From among the loose parts, find the following
hardware:
*4 Carriage Bolts, 5116-18 x 3/4
*4 He× Nuts 5/16-18
°4 Lockwashers, 5t16 External Type
1 Motor Pulley
1 Belt Guard "L" Bracket
1 Belt Guard Support Bracket
items marked with an astedsk (*) are shownactual size.
i
POSITIONING MOTOR ON MOTOR MOUNTING
BASE
Modet 113.298762
ONLY
BELT GUARD
"L" BRACKET
5/16-18 x 3/4 IN
CARRIAGE BOLT
1. Put the motor mounting base against theflat sudace
o! a workbench.
2. Position the motor so the end with terminal cover is
facing you.
3. Loosen both cradle clamp screws.
4. Put a square against the LEFT side of the motor and
against the top of the workbench.
MOTOR
PULLEY
G
5/16-18
HEX NUT
BELT GUARD
SUPPORT BRACKET
5/16 IN EXTERNAL
LOCKWASHER
LOOSEN BOTH CRADLE CLAMP SCREWS
5. Turn the motor inside the cradle clamps until the top
of both capacitors touch the square.
6. Tighten bothcradle clamp screws toholdthe motor in
this position.
I WARNING: Failure to properly InStall motor may
let workpleca strike capacitor cover during bevel
or compound miter cuts. Workpleca could biml
and kick back. You could be cUt or hit.
MOUNTING MOTOR ON MOTOR BASE
Model 113.298722 & 113.298762
1. Place Motoron Motor Base so thatshaft ispointingto
the right. Insert bolls through holes in Base, then
throughtheMotor MountingBase. Install Iockwashe_
and nuts, DO NOT TIGHTEN AT THIS TIME.
'_ MOTOR M2#NTING
SQUARE __ HAS
_,-_-_+_1"_1 o I WORKBENCH
WELDED MOTOR
MOUNTING BASE
I THESE TWO CARRIAGE BOLT
EDGES EVEN 5t16-18 X 3/4 IN.
LOCKWASHER
5/16 IN,
N "l" _'N_,_.J"3
u _._.=_ _
5/16-18
2. Position Motor sothat edge ofMotor Foot and Motor
Base are even. Slide Motor allthe way tothe RIGHT.
Slip the long part of the "L" Bracket fully under the
Motor so the short part is just undershaft (Model 113.
298722 only). Tighten the four nuts.
away from Motor. DO NOT TIGHTEN SETSCREW.
4. Install3/16 inch square key (furnished with Motor) in
INSTALLING BELT
Model 113.298722 & 113.298762
1. Lift Motor and insert the TWO PINS on Motor Base
into HOLES in Cradle. Push Motor inas far as it will
go.
BELT GUARD
INSERTED EVEN WITH
MOTOR END HUB
22
3ASE
2. Lowerthe blade, install Belton Saw Pulley and Motor
Pulley.
3. Sight along edges of both pulleys and move Motor
Pulley so that belt is parallel to the edges of both
Pulleys. Tighten the set screw in the Motor Pulley.
grooves inPulley and rnotorshaft. DO NOTTIGHTEN
SETSCREW.