Specifications

4. iMPORTANT: Measure the distance from end of
Motor sha_ to Pulisy. Mark this dimension down;
you will need It later when reinstalling the Pulley.
5. Make sure blade is90 ° totable, raise italltheway up.
6. Lift Motoruntiledge of washer iseven with end of slot
tighten pivot screw. Inthisposition, pullMotortoward
you (pinswill slideout of Cradle) untilBell is TIGHT,
tighten the two Motor Base Clamp Screws.
7. Loosen Pivot Screw slightly.
8. Lower the saw blade all the way down.
9. IMPORTANT: Motor should pivot freely down-
ward as blade Is lowered, if it does not, LOOSEN
the Pivot Screw some more.
10, Pivot Screw must be adjusted only tight enough to
allow Motor to pivotFREELY as blade is raised and
lowered. Thiswill maintain constanttension on Belt.
11. Put your hand around the belt halfway between the
two Pulleys and squeeze Belt untiltwo sides of Belt
touch. The Motorshouldmove freely as you squeeze
the Belt. If Motor does not movefreely, Belt tension
must be readjusted.
EDGE OF WASHER
EVEN WITH END
OF SLOT
SCREW
/
"L" BRACKET
MOTOR PULLEY
INSTALLING BELT GUARD
Model 113.298722
1. Remove the Belt and Motor Pulley.
2. Screws furnished with Guard are "SerfThreading".
Screw them intoholes inBeltGuardSupport Bracket,
then remove them.
3, Position Belt Guard Support Bracketand Belt Guard
Support as shown and installthe screws. Make sure
Motor shaft is in CENTER of hole in Support.
. MOTOR BASE
CLAMP SCREWS_
PIVOT
SCREW
TWO HOLES CLOSEST
BELT GUARD
SUPPORT
BELT GU/_RO
SUPPORT BRACKEt
10-32 X 1 tt IN*
SELF-THREADING
BELT GUARO SUPPORT SCREW
INSTALLING BELT GUARD
Model 113.298762
1. Remove the Belt and Motor Pulley.
2. Screws furnished with Guard are Self Threading."
Screw them intoholes in BeltGuard Support Bracket,
then remove them.
3. Position Belt Guard Support Bracket and Belt Guard
Support as shown and installthe screws. Make sure
Motor Shaft is in CENTER of hole in support.
"_ TWO HOLES CLOSEST
TOGETHER
BELTGUARD
SUPPORT BRACKET
BELT GUARD
/
CENTERED
PIVOT
SCREW
23 j
BELT GUARD SUPPORT