Specifications

geeing to know your saw
9 SAWeLADE
J 7 BLADE GUARD
8 TABLE INSERT
10 EXACT-I-CUT ANTIKICKBACK
PAWLS
6 MITER GAUGE
RIP FENCE
HOLES FOR
ATTACHING FACING
RiP FENCE
LOCK HANDLE
'4 TILT LOCK HANDLE
(UNDERNEATH TABLE)
2 ELEVATION HANDWHEEL
\
ON-OFF SWITCH 1 ON-OFFSWITCH
\
3 TILT HANDWHEEL
CAUTION: Beforetuming switch "ON", make
sure the blade guard is correc.y Installed and
operating properly.
The On-Off Switch has a locking feature. THIS
FEATURE IS INTENDED TO PREVENT UN-
AUTHORIZED AND POSSIBLE HAZARDOUS USE
BY CHILDREN AND OTHERS.
A. To turn saw ON, stand to either side ofthe blade,
never in line with it, insert finger under switch
lever and pull END of lever out.
AfterturningswitchON, always allowthe blade to
come up tofull speed before cutting.
Do not cyclethe Motor Switchon and off rapidly,
as this may cause the sawblade to loosen. Inthe
event this should ever occur, allow the sawblade
to come to a complete stop and retighten the
arbor nut normally, notexcessively. Never leave
the saw while the power in "ON".
B. To turnsaw OFF, PUSH lever in. Never leave the
saw untilthe cuttingtool has come to a complete
stop.
C. To lockswitchinOFF position,hold switchIN with
one hand, REMOVE key with other hand.
WARNING: Foryourown safety, lower blacis
or other cutting tool below table surface. (if
blade is tilled, return R to vertloal, 90°, posF
tlon.) Always lock the s_ltch "OFF". When
saw Is not In use, remove key and keep it in a
e place. Also, in the event of is power
lure (all of your lights go out) turn switch
oft, lock It and rentove the key. Tide w!lll
prevent the saw from starting up again when
the power comes back on.
KEY
(YELLOW PLASTIC)
f __y
25