Specifications

adjustments

3. Place the head of a combination square in the

GROOVE. Adjust blade of square so that it just

touches the tip of the MARKED tooth.

4. Move square to REAR, rotate blade tosee ifMARK ED

tooth again touches blade of square.

5. If tooth touches square at FRONT and REAR.

sawblade is PARALLEL to Miter Gauge Groove.

6. If toothdoes not touch the same amount, the mecha-

nism underneath must be adjusted to make the blade

PARALLEL to GROOVE.

A. Rear Trunnion must be moved TOWARD to com-

bination square ifthere isaspace between marked

tooth and end of square in step 4.

B. Rear Trunnion must be moved AWAY from the

square if marked tooth pushes square out of posi-

tion in the groove.

FRONT TRUNNION

REAR TRUNNION

7. Loosen all th tee screws that holdthe Rear Trunnion

and all three screws that hold the Front Trunnion.

NOTE: All six screws can be reached through back

of saw. Use a 9/16 inch wrench. To reach left-hand

Front Trunnion screw, tilt blade to 45°. After loosen-

ing screws, reposition blade at 90 °.

REAR-TRUNNION

SCREWS

RIGHT-HAND I CENTER (BEHIND HERE)

(BEHIND HERE)

/ \

FRONT-TRUNNION SCREWS

8. Using a wood blockand mallet, as shown, move Rear

Trunnion to right Or left as required to realign the

blade. If necessary, shift Front Trunnion in similar

manner; but do NOT move Front Trunnion unless

necessary. Recheck the alignment with the square,

then securely retighten all six Trunnion screws.

EDGE OF TRUNNION

CLAW HAMMER

PLACE BLOCK HERE

j WOOD BLOCK

EDGE OF

REAR OF SAW CRADLE