Specifications

BLADE TILT, OR SQUARENESS OF

BLADE TO TABLE

When the Bevel Pointer is pointing directly to the "0"

mark on the Bevel Scale, the sawblade should make a

SQUARE cut 90° to the table.

90° Position

To check for SQUARENESS:

WARN,NG: For your own ufety, turn switch J

' OFF" and remove plug from power source out-

let,

1. Raise blade all the way UP, raise Blade Guard.

2. TiLT blade a few degrees to theLEFT. Now,tilt blade

back to the RIGHT as far as itwillgo.

3. Place the square against blade. Make sure square is

not touching the TIP of one ofthe saw TEETH.

4. Operate the Tilt-Lock Handle (COUNTERCLOCK-

WISE) to loosen the Tilt Clamp screw.

5. NOTE: Handle is spdng loaded forengagementwith

screw head - must be pushed inward fordisengage-

ment whenever necessary to obtain a new gdp on

screw head.

I '" i JI!

:LAMP SCREW

;K HANDLE

6. Rotate Tilt Handwheel CLOCKWISE afewtumstotilt

blade. Now, rotate Handwheel COUNTERCLOCK-

WISE until it stops. Blade shouldnow be square with

table and Pointer should point to "0".

A. It blade is SQUARE to table;

1. Check Pointer,

B. IF POINTER DOES NOT point to the "0" mark on

the Bevel Scale;

1. Remove Elevation HandwheeL

2, Loosen screw and adjust Pointer using medium

screwdriver

3. Install Elevation Handwheel,

TILT HANDWHEEL

BEVEL SCALE

POINTER

,ADJUSTING SCREW

SCALE ADJUSTING

SCREW

POINTER AT

"9" POSITION