Specifications

adjustments
C. Ifblade is NOT SQUARE to table.., the 90° Stop
Screw must be ADJUSTED,
1. Unscrew 90° Stop Screw three to four turns
using 3/16 inch Hex "L"wrench.
2. Turn Tilt Handwheel clockwise one turn, then
tum Handwheel counterclockwise untilblade is
square with table.
3. Screw 90° Stop Screw IN until it stops. Check
once againfor squareness and readjust screw,
necessary.
45o Posrrtion
TILT blade to LEFT as far as itwill go.
1. Place an ACCURATE square against blade. Make
sure square is nottouching the TIP of one ofthe saw
TEETH.
Ifblade is 45° totable;
1. Check Pointer.
!
!
/
Q
90°
STOPSCREW
\
\
\
\
Ifblade is NOT 45oTO TABLE... STOP SCREW and
SCALE must be ADJUSTED.
1. LJnscrew 45= Stop Screw three to fourturns using
3/16 inch setscrewwrench.
2. Turn Tilt Handwheel until bladeis45 oto the table.
3, Screw 45° Stop Screw IN untilil stops. Check once
again and readjustscrew, if necessary.
!
!
©!
45 °
STOPSCREW
\
\
\
\
\
\
If POINTER DOES NOT point to the 45 ° markon the
scale;
1. Remove Elevation Handwheel.
2, Loosen two screws on Scale and adjust Scale until
Pointer pointsto 45° mark,
3. Install Elevation Handwheel.
o
TILT MECHANISM
The Handwheel shou
TILT HANDWHEEL
ADJUST THESE
TWO SCREWS
42