Specifications

maintenance
WARNING: For your own safety, turn switch "OFF"
and remove plug from power source outlet before
maintaining or lubricating your saw.
Do not allow sawdust to accumulate inside the saw.
Frequently blow out any dust that may accumulate inside
the saw cabinet and the motor.
Frequently clean your cutting tools with a solvent recom-
mended for gum and pitch removal.
A coat of automobile-type wax applied to the table will help
to keep the surface clean and allow workpieces to slide
more freely.
If the power cord is worn or cut, or damaged in any way,
have it replaced immediately.
Make sure the teeth of the Anti-Kickback Pawls are always
sharp. To sharpen:
1. Remove Blade Guard.
lubrication
The following parts should be oiled occasionally with SAE
No. 20 or No. 30 engine oil.
1. Tilt screw threads and pivot nut. (First clean with a sol-
vent recommended for gum and pitch removal.)
2. Elevation screw threads and pivot nut. (First clean with
a solvent recommended for gum and pitch removal.)
3. Cradle bearing points.
4. Bearing points in Guard Assembly, Miter Gauge and
Rip Fence.
7- f_
0 BENRING POINTS
2. Rotate Pawl toward rear of Spreader so that teeth are
above top of Spreader.
3. Hold Spreader with left hand and place Pawl over cor-
ner of workbench.
4. Using a small round file (smooth cut) sharpen the
teeth.
" /- -
sears recommends the following accessories
Item CAT. NO.
Caster Sets ...................................... 9-22222 or 9-22221
7 In. Molding Head Set ................................ See Catalog
7 In. Molding Head ....................................... See Catalog
8 In. Molding Head ....................................... See Catalog
MoldingJDado Insert for 7 In. Dia. Molding
or Dado Head ..................................................... 9-29997
Molding/Dado Insert for 8 In. Dia. Molding
or Dado Head ................................................. 9-22287
Work Light .................................................... See Catalog
7 In. Dia. Adjustable Dado Head .................. See Catalog
7 In. Dia. Dado Head ................................... See Catalog
Sanding Wheel ............................................ See Catalog
ITEM CAT NO.
Miter Gauge Stop Rods ...................................... 9-29924
Miter Gauge Hold-Down Clamp ......................... 9-29928
Taper Jig ....................................................... See Catalog
Universal Jig ................................................. See Catalog
Power Tool Know How Handbook ...................... 9-29117
Sears may recommend other accessories not listed in
manual.
See your nearest Sears store for other accessories.
Do not use any accessory unless you have receive_
and read complete instructions for its use.
'WARNING: Use only accessories recommended for this saw, Using other accessories may be dangerous. J
43