Specifications

trouble shooting
WARNING: For your own safety, turn switch "OFF" and always remove plug
from power source outlet before troubleshooting.
TROUBLE SHOOTING - GENERAL
TROUBLE
Excessive vibration
Cannot make square
cutwhen crosscutting.
Cut binds, burns or
stalls motor when
npp=ng.
Cut not true at 90° or
45° positions.
PROBABLECAUSE
1. Blade out of balance.
1. Miter gauge not adjusted
properly.
1. Dull blade or improper
tooth set.
2. Blade is Heeling.
3. Warped board,
4. Rip Fence not parallel to
blade.
5. Spreader out of alignment.
1. Stop collars not properly
adjusted.
Tilt and elevating f. Sawdust on threads of tilt
handwheel turn hard, screw or elevat=ng screw.
• 2. Bearing retainers too
tight.
REMEDY
1. Discard Blade and use a different blade.
1. See "Adjustments" section "Miter Gauge."
1. Sharpen or replace blade.
2. See "Adjustments" section, "Heeling Adjustment.."
3. Make sure concave or hollow side is facing
"down," feed slowly.
4. See "Assembly" section, "Aligning Rip Fence."
5. See "Assembly" section, "Installing Blade Guard."
1. See "Adjustments" section, "Blade Tilt, or
Squareness of Blade to Table."
1. See "Maintenance" and "Lubrication" sections,
2. See "Maintenance" section, "Tilt and Elevation
Mechanism"
TROUBLESHOOTING- MOTOR
NOTE: Motors used on wood working tools ar particularly susceptible to the
accumulation of sawdust and wood chips and should be blown out or "vacuurned"
frequently to prevent interferencewith normal motor ventilation,
reduction of 36% in
maximum power
output.}
44