Specifications

unpacking and checking contents
TOOLS NEEDED
Plier
Combination Square
Wrenchea
7/16 in, 1/2 in. 91"16 In.
Phillips Screwdriver
Medium Scra_dr|ver
Small Screwdriver
SIZE
Set Screw Wrenches
3/32 In.
1/8 In.
5/32 In.
COMBINATION SQUARE MUST BE TRUE,
STRAIGHT EDGE OF BOARD
3, 4" THICK. THIS EOGE MUST
BE PERFECTLY STRAIGHT.
DRAW LIGHT LINE ON _
BOARD ALONG THIS EDGE ; '_ _ /
L_ /
SHOULD BE NO GAP OR OVERLAP
HERE WHEN SQUARE IS FLIPPEO
OVER IN OOTTED POSITION.
r
Separate all parts from packing materials and check
each one with the illustrationand the listof Loose Parts
tO make certain all items are accounted for, before
discarding any packing material.
I WARNING: ff any parts are missing, do not at-
tempt to assemble the table saw, plug in the
power cord or turn the switch on until the missing
parts are obtained and are in_alle,(:l correctly.
Remove the protective oil that isapplied to the table top
andedges ofthetable. Use any ordinaryhouseholdtype
grease and spot remover.
WARNING: To avoid fire or health hazard, never ]
use gasoline, naptha, or similar highly volatile
isolvents.
Apply a coat of automobile wax to the table.
Wipe all parts thoroughly with a clean, dry cloth,
WARNING: For your own safety, never con_ !
plug to power source outlet until all assembly
!
stepsarecomplete, aad you have mad and under-
stand the safety and operating Instructions.
H
J
ITEM
A
B
C
D
E
H
M
Q
R
S
T
U
G
J
AM
F
K
L
N
O
P
il/ ..........
14
PARTNAME QTY.
Blade Guard and Spreader ........................... 1
Rip Fence ...................................................... 1
Owner's Manual ............................................ 1
Cast Iron Table Extensions ........................... 2
Miter Gauge .................................................. 1
Rip Fence Guide Bar with Rip Scale (Front]. 1
Support, Motor Base ..................................... 1
Rip Fence Guide Bar (Rear) ......................... 1
Side Stiffener ................................................. 2
Leg ................................................................ 4
End Stiffener ................................................. 2
Motor ............................................................. 1
Bag of Loose Parts
(Containing the followingitems)
Outlet, On/Off with Key ................................ 1
Handwheel .................................................... 2
Bracket, "L" Mounting (Model 113.298721) ... 1
Bag of Loose Parts ........................................ 3
Bag of Loose Parts
(Containing the following items)
Wrench .......................................................... 1
Belt, "V" 1/2 x 41 ........................................... 1
Pulley, 112dia. with 5/8 Bore ......................... 1
Spreader, Rod ............................................... 1
Blade Guard Support .................................... 1
Spreader Support .......................................... 1
£@
(MODEL 11_L29B762)
u
(MODEL 113.298722 i
8