Owner manual

15. IMPORTANT: To work properly, the Spreader
must always be PARALLEL to the sawblade and
adjusted so the cut workpiece will pass on either
side at the Spreader without binding or skewing
to the side.
NOTE: The Spreader is thinnerlhan the width of the
cut (KERF) by approximately six thicknesses of
paper.
KERF WOOD
____ L____
BLADE
/
SPREADER
LOOKING DOWN ON SAW
16. Make two folds in a small piece (6 x 6 inch) of ordinary
NEWSPAPER making three thicknesses.
The folded paperwill be used as a “spacing gauge".
17. Place Rip Fence on table. CAREFULLY move it
against blade so that it is parallel to the blade, and
just TOUCHES tips of sawteeth. Tighten Rip Fence
Lock Lever.
18. Insert folded paper between Spreader and Fence.
19. Using 7/16 wrench loosen the 1/4-20 hex head
screws so the Spreader can slide sideways.
20. Hold Spreader flat against Fence. Tighten screws
using 7/16 inch wrench.
21. To remove Biade Guard and Spreader, loosen
Thumbscrew. DO NOT LOOSEN OTHER SCREWS.
This lets you remove and replace the Guard without
disturbing the Spreader alignment.
MOUNTING THE MOTOR
Model 113.298721 & 113.298761
Check Motor Rotation
1. The Motor must rotate CLOCKWISE when viewed
from the 5/8 inch shaft.
2. MAKE SURE "KEY IS REMOVED FROM SHAFT.
3. Place the Motor on your workbench or on the floor.
4. Plug the cord into a properly grounded outlet (See
"MOTOR SPECIFICATIONS AND ELECTRICAL
REQUIREMENtS" section) Notice the rotation of
the shaft. If it is not fuming CLOCKWISE, do hot
assemble or attempt to operate saw until motor with
correct rotation is obtained.
KEY
5/8 IN.
DIA. SHAFT
21